-->
Welcome, Guest
Username: Password: Remember me

TOPIC: Dolibarr in RedHat 8

Dolibarr in RedHat 8 5 days 1 hour ago #38165

Please your help to install full Dolibarr in RedHat 8, rpm dowloaded (dolibarr-10.0.1-0.4.noarch.rpm) but when install giving me following message:

[linux1@afflicscloud ~]$ sudo yum install dolibarr-10.0.1-0.4.noarch.rpm
Loaded plugins: product-id, search-disabled-repos, subscription-manager
This system is not registered with an entitlement server. You can use subscription-manager to register.
Examining dolibarr-10.0.1-0.4.noarch.rpm: dolibarr-10.0.1-0.4.noarch
Marking dolibarr-10.0.1-0.4.noarch.rpm to be installed
Resolving Dependencies
--> Running transaction check
---> Package dolibarr.noarch 0:10.0.1-0.4 will be installed
--> Processing Dependency: php >= 5.3.0 for package: dolibarr-10.0.1-0.4.noarch
repo.mysql.com/yum/mysql-connectors-comm.../repodata/repomd.xml: [Errno 14] HTTP Error 404 - Not Found
Trying other mirror.
To address this issue please refer to the below knowledge base article

access.redhat.com/articles/1320623

If above article doesn't help to resolve this issue please open a ticket with Red Hat Support.



One of the configured repositories failed (MySQL Connectors Community),
and yum doesn't have enough cached data to continue. At this point the only
safe thing yum can do is fail. There are a few ways to work "fix" this:

1. Contact the upstream for the repository and get them to fix the problem.

2. Reconfigure the baseurl/etc. for the repository, to point to a working
upstream. This is most often useful if you are using a newer
distribution release than is supported by the repository (and the
packages for the previous distribution release still work).

3. Run the command with the repository temporarily disabled
yum --disablerepo=mysql-connectors-community ...

4. Disable the repository permanently, so yum won't use it by default. Yum
will then just ignore the repository until you permanently enable it
again or use --enablerepo for temporary usage:

yum-config-manager --disable mysql-connectors-community
or
subscription-manager repos --disable=mysql-connectors-community

5. Configure the failing repository to be skipped, if it is unavailable.
Note that yum will try to contact the repo. when it runs most commands,
so will have to try and fail each time (and thus. yum will be be much
slower). If it is a very temporary problem though, this is often a nice
compromise:

yum-config-manager --save --setopt=mysql-connectors-community.skip_if_unavailable=true

failure: repodata/repomd.xml from mysql-connectors-community: [Errno 256] No more mirrors to try.
repo.mysql.com/yum/mysql-connectors-comm.../repodata/repomd.xml: [Errno 14] HTTP Error 404 - Not Found
The administrator has disabled public write access.
Time to create page: 0.058 seconds